Outdoor steps, ramps and walkways are where winter slips start: rain, wet leaves, frost and early-morning darkness all arrive at once. Anti-slip GRP (glass reinforced polyester with a resin-coated gritted surface) is a practical way to add lasting grip to an existing surface without replacing it. Mats4U stocks four anti-slip GRP products for this job: stair treads, stair nosings, flat sheet and decking strips, all in our GRP range.
This guide explains what GRP can and cannot do in icy weather, which product suits which problem, and how to measure and fix it. All sizes, prices and test details are taken from the live Mats4U product pages (checked 16 November 2026).
Table of contents
- What GRP can and cannot do in winter
- Which GRP product for which problem
- Stairs: treads or nosings?
- Ramps, walkways and platforms: flat sheet
- Decking and boardwalks: decking strips
- Measuring, cutting and fixing
- A winter checklist for steps and ramps
- Frequently asked questions

What GRP can and cannot do in winter
What it does: the gritted GRP surface gives strong grip on wet, dry and oily surfaces. Every Mats4U listing in this guide says the product has been slip tested to BS 7976-2 (the pendulum test). The treads, nosings and flat sheet are described as having extremely low slip potential when dry and low slip potential in wet, oily and greasy conditions. GRP will not rust like metal treads or rot and warp like timber, and the listings give a temperature range of -50°C to +110°C, so it copes with frost, rain and sun all year.
What it does not do: GRP does not stop ice or snow forming on top of it. Once a layer of ice or compacted snow covers the grit, people are walking on the ice, not the GRP. The Stair Nosing listing itself advises keeping stairways free of mud, leaves, snow and ice so the surface performs as intended. So GRP is the permanent part of a winter plan, not the whole plan.
The Health and Safety Executive's slips and trips FAQs advise identifying the outdoor areas most likely to ice over (building entrances, car parks, pedestrian walkways, shortcuts, sloped areas and areas constantly in the shade or wet) and gritting them when frost, ice or snow is forecast, ideally early in the evening or early in the morning before people arrive. Fitting GRP to the steps and ramps on those routes means they still have a high-grip surface on the many wet, cold days that are not icy, and once grit or clearing has done its job.
Which GRP product for which problem
Listed prices are from the product pages; shipping and VAT are calculated at checkout, and prices can change.
| Product | What it covers | Thickness and sizes | Colours | Listed price |
|---|---|---|---|---|
| Anti-Slip GRP Stair Treads | The whole walking surface of a step | 4mm thick, 55mm x 345mm profile; 60cm to 3m lengths | Black, Black/Yellow, Black/White, Yellow | From £25.54 |
| Anti-Slip GRP Stair Nosing | The leading edge of a step | 4mm thick; 55mm x 55mm (40cm to 3.6m) or 30mm x 70mm (75cm to 3m) | Black, Black/Yellow, White, Yellow | From £7.09 |
| Anti-Slip GRP Flat Sheet | Ramps, walkways, platforms and access routes | 4mm thick; sheets from 800mm x 1220mm to 1220mm x 3000mm | Black, Grey, Yellow | From £66.05 |
| Anti-Slip GRP Decking Strips | Strips of grip across decking and walkways | 3mm thick; 50mm or 90mm wide; 750mm to 3m lengths | Black, Yellow, Beige | From £8.47 |

Stairs: treads or nosings?
The two stair products do different jobs, and the right one depends on where the problem is:
- Stair nosing covers and protects the leading edge of each step. If the front edge is worn or slippery but the rest of the step is sound, a nosing may be all you need. Anti-Slip GRP Stair Nosing comes in two profiles, 55mm x 55mm and 30mm x 70mm, and can be supplied pre-drilled.
- Stair treads cover the walking surface of the step, where people actually put their feet. If the step itself is worn, chipped, damaged or slippery, a full Anti-Slip GRP Stair Tread gives a continuous high-grip surface and also tidies the look of tired steps. The tread profile is 55mm x 345mm, 4mm thick.
Colour matters on stairs. The Stair Nosing listing notes that high-contrast colours are often chosen to make stair edges easier to distinguish, particularly in public buildings, workplaces and areas with lower light levels, which is most places on a winter afternoon. Treads are offered in Black, Black/Yellow, Black/White and Yellow; nosings in Black, Black/Yellow, White and Yellow. If your building has specific accessibility requirements, check them for your project, as the listing recommends.

Ramps, walkways and platforms: flat sheet
Anti-Slip GRP Flat Sheet is 4mm thick and fits directly over suitable existing concrete, metal, wood and other substrates, which makes it the option for a slippery ramp, walkway, platform or access route where the surface underneath is structurally sound but lacks grip. It is not a replacement floor; it is a high-grip overlay.
- Sizes from 800mm x 1220mm up to 1220mm x 3000mm, in Black, Grey or Yellow, and it can be cut to size.
- The listing describes it as suitable for heavy footfall and wheeled areas, and its low profile as suitable for wheelchair users.
- Yellow gives a highly visible finish where you want to mark out a route; Black and Grey are more understated.

Decking and boardwalks: decking strips
Timber decking turns slippery when it stays wet through the winter. Anti-Slip GRP Decking Strips fix across the boards to add bands of grip without covering the whole deck. They are 3mm thick, 50mm or 90mm wide, in lengths from 750mm to 3m, in Black, Yellow or Beige, and can be cut to size or supplied pre-drilled. The listing gives pendulum test values to BS 7976-2 of 73 dry, 60 wet and 45 with oil. For comparison, HSE's guidance on assessing floor slipperiness classes a pendulum test value of 36 or more as low slip potential.
For more on decking strips, see our earlier post on GripGuard decking strips for safer outdoor spaces.

Measuring, cutting and fixing
- Measure every step. Measure the width and depth of each individual step rather than assuming they are all identical; older staircases often vary.
- Allow for the cutting tolerance. Bespoke cuts have a stated tolerance of plus or minus 3mm.
- Plan sheet layouts first. Where several flat sheets go together, plan the layout before cutting to keep cuts and waste down.
- Prepare the surface. Remove loose material, dirt and grease so the tread or sheet sits securely and the fixing can work.
- Choose the fixing for the substrate. Treads, nosings and decking strips can be supplied pre-drilled, and screws and adhesive are available separately (they are not included). Concrete, timber and metal may each need a different method; the Stair Nosing listing notes that a combination of mechanical fixings and adhesive often gives the most secure, long-lasting result.
A winter checklist for steps and ramps
- Walk the routes people actually use, including shortcuts, and note every step, ramp and walkway that gets wet, shaded or icy.
- Fit permanent grip where it is needed: nosings for worn edges, treads for worn or slippery steps, flat sheet for ramps and walkways, decking strips for decking.
- Use high-contrast colours on step edges so they stand out in poor light.
- Keep a gritting and clearing plan for frost, ice and snow, as HSE advises; GRP does not replace it.
- Keep surfaces clear of leaves and mud, and put proper entrance matting inside the door so wet feet do not carry the problem indoors. Our guide to how long an entrance mat should be explains the sizing.
Related reading
Frequently asked questions
Q1: Does anti-slip GRP stop ice forming on steps?
A1: No. GRP gives a gritted, high-grip surface in wet, dry and oily conditions, but it does not stop frost, ice or snow forming on top of it. The Stair Nosing listing itself advises keeping the stairway free of snow and ice. HSE guidance is to assess the risk and use grit, or something similar, on areas prone to ice when freezing temperatures are forecast.
Q2: Should I choose GRP stair treads or stair nosings?
A2: If only the front edge of each step is worn or slippery and the rest of the step is sound, a stair nosing may be all you need. If the walking surface of the step is worn, damaged or slippery, a full GRP Stair Tread covers the area where people actually put their feet.
Q3: What sizes are the Mats4U GRP stair treads and nosings?
A3: Anti-Slip GRP Stair Treads are a 55mm x 345mm profile, 4mm thick, in standard lengths from 60cm to 3m. Anti-Slip GRP Stair Nosing comes in 55mm x 55mm (lengths from 40cm to 3.6m) or 30mm x 70mm (lengths from 75cm to 3m). Both can be cut to size, with a stated cutting tolerance of plus or minus 3mm.
Q4: Can GRP flat sheet be used on a ramp?
A4: Yes. The Anti-Slip GRP Flat Sheet listing names walkways, platforms, ramps, flooring and access routes. It is 4mm thick, fits over suitable existing concrete, metal, wood and other substrates, and is listed as suitable for wheeled areas and, thanks to its low profile, for wheelchair users.
Q5: How are GRP treads, nosings and sheets fixed?
A5: They are fixed directly to the existing surface. Treads, nosings and decking strips can be supplied pre-drilled, and screws and adhesive are available separately. The right method depends on the substrate; the Stair Nosing listing notes that a combination of mechanical fixings and adhesive often gives the most secure, long-lasting result.
Q6: How slip resistant is anti-slip GRP?
A6: The listings say each product has been slip tested to BS 7976-2. The treads, nosings and flat sheet are described as having extremely low slip potential when dry and low slip potential in wet, oily and greasy conditions. The Decking Strips listing gives pendulum test values of 73 dry, 60 wet and 45 with oil; HSE classes a pendulum test value of 36 or more as low slip potential.
Q7: Which colour should I choose for stair edges?
A7: Stair treads come in Black, Black/Yellow, Black/White and Yellow, and nosings in Black, Black/Yellow, White and Yellow. The Stair Nosing listing notes that high-contrast colours are often chosen to make stair edges easier to see, particularly in public buildings, workplaces and areas with lower light levels.
Q8: Can GRP be used outdoors all winter?
A8: Yes. The listings describe the products as suitable for indoor and outdoor use, resistant to weather, UV and chemicals, with a stated temperature range of -50°C to +110°C. GRP will not rust like metal or rot like timber. Keep it clear of leaves, mud, snow and ice so the gritted surface can work.
Not sure which profile, size or colour you need? Send your measurements and a photo of the steps or ramp through our contact page, and we will suggest the right option from the GRP range.
See recent installs and new products from Mats4U on Instagram, Facebook and LinkedIn.
